Hello list:
Even before my Rat-co frame-off restoration, my car sat slightly
lower (3/4") on the driver's side than the passenger side. Spring swapping
did not solve this. Currently, I have shortened springs all the way around
with 1/2" spacers in the rear only. In order to get things level, I am
planning to remove the spacer in the R rear, and add a 1/2" spacer in the L
front. I'm assuming this will not have an adverse effect on my suspension
uniformity. I will go over the suspension installation first, looking for
errors, but I cannot imagine having it wrong after all the detailed work I've
done. Do you think my approach would cause any other peripheral problems?
I'm thinking that if I can get the car level and the spring heights and rates
are the same on both sides, the spacers wouldn't have a negative impact.
Your opinions are invited and welcome.
Andy
CD6746L
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|