Jim---No dressing is necessary for the manifold gasket.
The studs for the manifolds aren't going anywhere. In fact, they can sometimes
resist coming out. I use just a light smear of anti-seize on the threaded end
that goes into the head, and just snug them up. (The non-threaded shank will
bottom out the stud)
No gorilla tactics necessary!
Dick
-----Original Message-----
From: Jim Hurley
Sent: Sunday, October 11, 2009 10:27 AM
To: 6pack@autox.team.net
Subject: [6pack] Manifold Studs and gasket
Hello,
I had a cracked exhaust manifold and wanted to replace my exhaust system, so
the whole thing came out. I got new studs and nuts, and a new gasket. Which
brings up several questions -
1. Should I use Locktite or something similar on the studs to hold them in
the head better?
2. Should I put some gasket compound or coating on the gasket?
That's all for now.
Thanks in advance,
Jim Hurley
"I'd rather be upside down in my kayak than rightside up at my desk."
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
You are subscribed as tr6taylor@webtv.net
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|