I haven't looked back since installing one of the passenger foot well 'direct
pull' contraptions.
Kendall
________________________________
From: "Foster, Stan (HP IT)" <stan.foster@hp.com>
To: "6pack@autox.team.net" <6pack@autox.team.net>
Sent: Tuesday, September 29, 2009 4:16:42 PM
Subject: Re: [6pack] Hood latch (catch) assembly
The original unit wasn't too bad, the repro ones I have tried are rubbish. If
you cant refurb your original (degrease, media blast, paint) then I would go
to eBay and try and find a good used one and refurb that before I wasted my
time and money on the repro latches.
Stan
-----Original Message-----
From: 6pack-bounces@autox.team.net [mailto:6pack-bounces@autox.team.net] On
Behalf Of Robert M. Lang
Sent: Tuesday, September 29, 2009 7:04 PM
To: Jerry C Shaw
Cc: 6pack@autox.team.net
Subject: Re: [6pack] Hood latch (catch) assembly
> Anyone have an alternative for the wimpy products offered by the Big Three
as
> substitutes for the Hood (a.k.a. Bonnet) latch assembly? Reference: TRF
> 619580 or Moss 802-275.
> Jerry
Do you want to elaborate?
The stock piece wasn't made from cast-iron (e.g. it was pretty wimpy).
rml
---------------------------------------------------------------------------
Bob Lang Triumph TR6!! | This space for rent
2009 NER Solo Chair |
Voice:617-253-7438 | Cell: 339-927-4489
---------------------------------------------------------------------------
_______________________________________________
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
You are subscribed as mailkendall@sbcglobal.net
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|