Yea - I saw that too and it looked cool on the car. I have three 3 inch K&N
air filters and just want to get some cold fresh air to them. I ordered
some ducting and a duct flange from Spruce aircraft and will create a
clamp/bracket that will secure the duct end near the carbs off of the
passenger front stay bar attachment nut. If this doesn't make sense, it's
because the cold beer has not flowed yet. I love the look of a low budget
racer!
Cheers,
Jim Henningsen
-----Original Message-----
From: Al Salvatore [mailto:tr6parts@charter.net]
Sent: Wednesday, June 24, 2009 8:18 PM
To: 6pack@autox.team.net; James Henningsen
Subject: Re: [6pack] Cold air intake
If you have triples, I've seen where someone had take two air cleaners and
sectioned them so they would fit the triple set-up.
Al
----- Original Message -----
From: "James Henningsen" <trguy@cfl.rr.com>
To: "'Dave from Calgary'" <YYCTR6@shaw.ca>; <6pack@autox.team.net>
Sent: Wednesday, June 24, 2009 5:31 PM
Subject: Re: [6pack] Cold air intake
> Dave:
> Thanks for the idea and a great setup for the twin carb. The source for
> the
> duct flange is a big help.
> Jim Henningsen
>
> -----Original Message-----
> From: Dave from Calgary [mailto:YYCTR6@shaw.ca]
> Sent: Tuesday, June 23, 2009 8:55 PM
> To: 'James Henningsen'; 6pack@autox.team.net
> Subject: RE: [6pack] Cold air intake
>
> To quote the PO of my car who did the very same thing:
>
> "The simple solution that I did was to buy the twin-snout air cleaner
> housing
> from an early ('69 - '70) TR6 and run 2 paper hoses (the ones that are
> sold
> for
> carb preheat) to the rad shroud just above and to the left of the carbon
> canister. I bought a couple of aluminum duct flanges from
> http://www.aircraftspruce.com/catalog/appages/ductflanges.php and rivited
> them
> to the shroud where I slipped the hoses on. Seems to work great with the
> stock
> carb setup. "
>
> And here's the result: http://lbcs.ca/images/P1080787_1024x768.jpg
>
>
> -----Original Message-----
> From: 6pack-bounces@autox.team.net [mailto:6pack-bounces@autox.team.net]
> On
> Behalf Of James Henningsen
> Sent: June-23-09 6:38 PM
> To: 6pack@autox.team.net
> Subject: [6pack] Cold air intake
>
> Anyone have a source for an inexpensive cold air intake setup for an
> aluminum shroud radiator duct. I know Richard Good has a nice setup, but
> I
> am looking for the economical "racer" look. I am thinking of some sort of
> tubing connector mounted to the shroud that the flexible tubing could
> clamp
> to and then have the tube end right in front of the front carb and have a
> clamp/adapter to secure. Anyone have some pics and a parts source they
> are
> willing to share. Many thanks,
>
> Jim Henningsen
>
> 75 TR6 (triple ZS)
>
> Maitland, FL
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|
