Ken, these badges may have been messed with and stuck on with trim tape etc
but if it is unmolested it will have two pins close to the ends that are a
push fit into some plastic inserts that go into holes in the rear panel. You
should be able to push a thin flat blade behind it close to each end and
gently lever it off. The OD drive hangs on the pins that are at the back of
the TRIUMPH badge.
Stan
-----Original Message-----
From: 6pack-bounces@autox.team.net [mailto:6pack-bounces@autox.team.net] On
Behalf Of Ken
Sent: Saturday, January 10, 2009 12:04 PM
To: 6pack
Subject: [6pack] Removing rear Badge
Thanks for all the info on removing the body panels /fenders - the deed is
well underway.
One little thing that I haven't yet figured out. On the R/rear is the
"Triumph / Overdrive" badge. I've been looking at it, but can't figure out
how it's removed without damage.
How do I do it safely?
Thanks
Ken Davis
73 TR6
Maricopa, Sonoran Desert, AZ
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|