David,
Your comments seem to describe an SU Tool Kit. These tools are used to
gauge if the pistons in SU carbs operate at a synchronized level.
I am not aware that this kit can be used with Strombergs.
Others may confirm.
Henri
On Fri, Nov 21, 2008 at 6:57 AM, <davgil@aol.com> wrote:
> Reading the posts about ways to balance carbs made me think of a tuning
>device that was in the toolbox of my 1976 TR6 when I purchased it, but that I
>have never tried.? As I recall, this is a combination of of an indicator to
>set float height along with two rods that go into the carbs with small wires
>atop them each of which?has a 90 degree bend.? The principle appears to be to
>adjust idle speed until the two wires (which each point to the other carb due
>to the bend) are equal and move simultaneously.? Has anyone else seen this
>device and does it work??
> David Gill
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|