HI JERRY,
I TOO, NEEDED A REPLACEMENT FOR THE ORIGINAL CONNECTOR WHEN INSTALLING MY
DAN MASTERS POWER BLOCK AND WIRING HARNESS. I FOUND THAT A STANDARD 1/4"
FEMALE SPADE CONNECTOR WITH THE PARTS THAT CLAMP AROUND THE 1/4" MALE END
OPENED UP SLIGHTLY (TO FIT SNUGGLY AROUND THE TWO POSTS OF THE PDWA) MADE AN
ACCEPTABLE REPLACEMENT IN MY CASE. I USED A SMALL NEEDLENOSE PLIERS TO OPEN
UP THE SIDES OF THE SPADE CONNECTOR SO THAT IT SLIPS SNUGGLY AROUND THE TWO
POSTS OF THE PDWA. HOPE THIS HELPS!
RANDALL NIFFENEGGER
'74 TR6, WHITE, BACK ON THE ROAD SOON
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|