Shawn,
If I understand your rant correctly, this may help you. I have dual Z-S
with the stock box and heat shield. I got tired of the lining up of the holes
so I got a threaded rod to fit into one bolt hole in each carb. I cut two
pieces to the proper length and filed the ends nice and flat and smooth. I
threaded one into each carb and then run the heat shield and the box onto the
rod
sticking out and they hold it in place while I run in the remaining bolts.
When I am done with that I put a nut on the end of the threaded rod to hold
the box on and adjust the rod so when the nut is tightened down on the box the
rod does not stick out past the nut.
YMMV
David Lylis
69 TR6 CC26160L
60 TR3A TS74461LO
**************Gas prices getting you down? Search AOL Autos for
fuel-efficient used cars.
(http://autos.aol.com/used?ncid=aolaut00050000000007)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|