Pete, the voltage regulator for the instruments is a small device attached to
the back of the speedo. It is secured by a single screw and it is probably
necessary to remove the speedo to get to it.
Stan
-----Original Message-----
From: 6pack-bounces+stan.foster=hp.com@autox.team.net
[mailto:6pack-bounces+stan.foster=hp.com@autox.team.net] On Behalf Of Pete
Kronberg
Sent: Sunday, May 18, 2008 11:20 AM
To: 6pack@autox.team.net
Subject: [6pack] Overvdriving gauges
Hey Folks,
I suspect that I've got to much voltage to my gauges- full tank pegs the
needle WAY beyond full, and when bone dry reads 1/4 tank...temp gauge reads
~25-30% too hot, etc.
Now, I understand that for the 12-volt electrics, there is a resistor(?) that
limits to 10-volts for the gauges to prevent overdriving...
Can anyone tell me more about this, and where this voltage limiter is
located?
Thanks,
Pete
CF38421U
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|