>If anyone can help me locate the following part, to
fit the 1970-1972
TR6 driver's seat, I'd be extremely grateful.
LH Seat seat-back support wire, lower wire, outer. TR6
1970-72 (the
>seat with fixed headrests)
Tom,
I had to make some of these for my TR250 this past
spring. I used a wire that we use in building chairs
where I work. Some of these larger wires required two
piece fabrication where I welded the two pieces with
an overlap. I bent the wires with heat in a small
fixture I made to hold the wire end or used the vise.
If you cannot find a suitable wire I could send you a
length. The proper wire that will hold it's shape is
an ASTM 407-93 type c that I used. If you cannot find
a hardedned wire I could send you a piece. Contact me
off list.
Patrick Bloem
68 TR250
73TR6
86 Vandenplas
East Grand Rapids, Michigan
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|