Hi Al,
If I were to do it, I would cut out the horizontal shape of power bulge in
the TR6 hood.
Then cut out the power bulge from the TR4 hood, leaving a small margin around
the edge.
Then I would fit the power bulge from underneath and secure it with tack
welds.
Then go from there..........
Joe A
> I have seen some TR6's with a TR4 power scoop or hood buldge grafted on.
> I was wondering how this was accomplished.
> Did they take a TR250 hood and cut off the end and attach the TR6 end.
> Or did the cut out the power scoop and spot weld it to the TR6 hood and
> feather it in.
> I had met the fellow that was doing it at a TRF summer party years ago. But
> I wasn't paying attention as to how it was done.;
> just thought it looked pretty neat.
> Since I could see the indentation of the buldge from the underneath, I don't
> believe it was spot welded.
>
> Any ideas?
>
> Al Salvatore
> polished intakes is the game
> www.triumphowners.com/624
>
</HTML>
|