Rick,
Correction: Change the word Vertical to Horizontal in the paragraph below
Sorry, Greg Perry
-----Original Message-----
>From: Greg Perry <rgperry@earthlink.net>
>Sent: Oct 22, 2007 5:22 PM
>To: richard.r.olson@faa.gov, 6pack@autox.team.net
>Subject: Re: [6pack] Fw: New springs - Help!
>
>Rick,
>
>The lower control arm needs to be vertical with respect to the ground. This
>will give you access to the inner nuts. With the weight of the car supported
>with a jack stands on the frame, I use a section of 2" x 4" to support the
>control arm under the trunnion so that the arm is about vertical. Greg Perry
>
>>Q2 -
>>The bigger only - The spring pan, my tool with a 1" X 3" alum, 1/2"
>>threaded, nuts and the spring is IN
>>but not much compressed. But I can't get the 2 nuts on the inner sides
>>(close to the frame).
>>
>>How can I do this?
>>
>>Thank,
>>Rick Olson ("being carefull!")
|