OK,
#2 & #4 cylinders are not firing. this is by pulling
each lead & swapping plugs. i'm fairly certain it's
not the wires...i tried other wires.
going in to adjust valves...
any more thoughts?
todd
--- Todd Bermudez <red_tr250@yahoo.com> wrote:
> All,
>
> Having an interesting issue with my '74 TR6 running
> rough between 1100-1400 RPMs. It seems to idle OK
> just around 900 or so, but when slowly accelerating
> at
> a stand still I can feel a vibration & when under
> load...wow!
>
> To date, I've switched out the plugs,cap,rotor
> button,
> & wires. I've also replaced the oil seal in the air
> valve in the back carb as it was NOT hold any oil &
> dumping it. I'd thought this may've been my
> problem,
> but NO.
>
> After having done all the above work, I balanced the
> carbs & it seemed to run OK. So, it's 8pm & there's
> no food. I decide to venture down to White Castle &
> pick up some grub. Well, just as I got close it
> started missing again...I mean it seems to smooth
> out
> over 1400. I guess that could be a cylinder not
> firing still?
>
> Any thoughts?
>
> Todd Bermudez
> CD198L
> CF25768UO
>
____________________________________________________________________________________Luggage?
GPS? Comic books?
Check out fitting gifts for grads at Yahoo! Search
http://search.yahoo.com/search?fr=oni_on_mail&p=graduation+gifts&cs=bz
|