On Wed, 25 Oct 2006, Richard Seaton wrote:
> Collective,
>
> My throwout bearing has started squeaking not very loudly but a little. The
> pins were installed to align the tranny. The squeaking quits when very light
> pressure is applied to the clutch pedal. I'm assuming that the spring may have
> lost some tension. What I'm thinking of doing is to relocate the spring to add
> a little more preload to the bearing. So what say ye all to that.
>
> PS Had the TR up to 104 mph today (and still pulling) and about a mile after
> after slowing down I saw an unmarked state police and then a county sherif.
If you didn't see them in your rear-view mirror with thier lights on,
consider this your lucky day.
On your way home, buy a lottery ticket.
What the heck, right?
30+ over in my state results in a serious fine and insurance "points" ($50
each per year) for close to 6 years! OUCH. Figure $300 plus the points
over time, total expenditure? over $600.
> Richard Seaton
regards,
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | At or Under Posted MPH
Consultant MIT unix-linux-help |
Voice:617-253-7438 FAX: 617-258-9535 | Cell: 339-927-4489
------------------------------------------------------------------------------
|