Hugh:
I have been following this thread, and I must say I do not
understand. Doh!
What exactly is getting "elongated"? Is the center bore of the
bushing moving so that the bolt hole is no longer centered? Or is the
bushing somehow getting extruded out of the trailing arm, or both, or
neither? Does someone have a picture posted somewhere?
Clueless as always,
Vance
-----Original Message-----
From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net] On
Behalf Of Hugh Barber
Sent: September 11, 2006 4:00 PM
To: Richard Seaton
Cc: 6 Pack
Subject: Re: sorry not Good parts TA bushings!! but Urethane bushings
Richard Seaton wrote:
> oopps, the bushings were urathane bushings as Good doesn't sell
urethane
> ones,
>
Richard,
I had a set of the polyurethane TA bushings that elongated just as yours
did. I replaced them with Richard Good's nylatron bushings and so far -
so good (no pun intended).
The poly ones were used with stock brackets when they elongated.
Hope this helps,
Hugh Barber
Stafford, VA
'73 TR6
|