Cary:
On the rear, left hand corner of the head (below the valve cover
and above the head gasket) there is a 5/16" bolt that screws into the
head, with a copper washer underneath. Remove that bolt and washer and
screw in the line there.
It will be interesting to see what you think of advantages of
the oil line. They are rumored to cause smoking and high oil
consumption. With a freshly rebuilt motor you will probably not see this
issue, but you never know...
Vance
-----Original Message-----
From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net] On
Behalf Of Cary Henry
Sent: August 17, 2006 9:32 AM
To: 6pack@autox.team.net
Subject: Rocker Oil Supply Line
I am finally reassembling my motor that I just rebuilt, and I have a
rocker
oil supply line that I purchased from BPnorthwest.com I understand
that
one end of the line connects to the oil pressure fitting on the driver's
side of the block, but where does the other end connect? The line came
with
no directions, and I don't see any holes in the head which look like the
correct spot.
Thanks,
Cary
|