On Tue, 18 Jul 2006, Alan Salvatore wrote:
> I am in the process of removing the rear brake cylinder.
> There is a retaining clip that doesn't want to move.
> what has anyone used to deal with it.
Use a die grinder to remove the "tabs" on the locking plate. Then just use
a soft drift to pound out the plates.
Obviously, if you grind the tabs off, you need new locking plates.
regards,
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-linux-help |
Voice:617-253-7438 FAX: 617-258-9535 | Cell: xxx-xxx-xxxx
------------------------------------------------------------------------------
|