Dave,
The rear hardtop mounting bolt holes have an adjusting nut. I assume that the
adjusting nut raises and lowers the mounting height of the rear mounting deck
of the hardtop. How does one know when it is adjusted properly?
Thanks,
Greg Perry
72 TR6
-----Original Message-----
>From: Dave1massey@cs.com
>Sent: Jul 4, 2006 8:48 PM
>To: sandner@worldnet.att.net, triumphs@autox.team.net
>Cc: 6pack@autox.team.net
>Subject: [TR] Re:
>
>In a message dated 7/4/2006 12:38:27 PM Central Standard Time,
>sandner@worldnet.att.net writes:
>> listers,
>> i have today acquired a 'ka-ka' brown hard top to complete my BMIHT birth
>> cert.
>> do i have to completely remove the soft top to install?
>> there are 2 bolt holes in front of the rear window, where do those bolts go?
>> TIA
>> randy sandner
>>
>No but you do have to dismount the rear attachment since the hardtop uses the
>same interface surface. Also, the B-pillar mounting brackets will prevent
>the top from being raised. But you can leave the folding top on the car if
>you
>have no better place to store it.
>
>Dave
>71 TR6
|