I have two sets of HS 6 waxstat carbs.
in One set of HS 6 waxstat carbs the brass butterfly is marked 21.5.
The second set has a shorter neck on the domes; and the butterflies are marked
20.5.
The openings seem to be the same ( rough measurement with tape measure).
The lower chambers look the same.
I probably know the answer to this question already, but I've got to ask it.
If these are basically the same carb; but with neck on one being shorter;
could the short one be used with two of the taller ones on a triple set up.
5/8 inch neck vs 1 inch neck on the domes.
I don't know the significance of the taller or shorter neck. Unless the
short neck means its not an HS 6.
thanks
Al Salvatore
|