February 18 is the day! The body is finally going back down after 2 1/2
years. I have the body mounting kit from TRF and have copies of the page
from the catalog and a few strong backs with weak minds. From the looks of
things in the catalog details, it appears that we get some rubber, the body,
some more rubber, and a bolt with washers. I assume the weather strip
adhesive tube shown on the page is for securing the rubber strips to the
frame. Are there any pitfalls I should be looking for? Is there anything
additional that I should do while putting the body in place? Any input would
be greatly appreciated. Maybe I'll actually be able to drive it again this
summer.
Thank you,
John Zimmerman
Mfg. Planning / Traffic
Demag Plastics Group
11792 Alameda Drive
Strongsville, Ohio 44149-3011
Phone: (440).876.6251
Fax: (440) 876.8977
email: john.zimmerman@dpg.com
DISCLAIMER:
The information transmitted is intended only for the person or entity to which
it is addressed and may contain confidential and/or legally privileged
material.
If you received this in error, please contact the sender and delete the
material
from any computer. Any review, retransmission, dissemination or other use of,
or
taking of any action in reliance upon, this information by persons or entities
other than the intended recipient is prohibited.
You have asked us to correspond with you via the Internet per e-mail. However,
the written version of our document signed by us is the only authoritative
version.
Please note that e-mail correspondence can be lost or falsified, with or
without
any interference by third persons. Conventional e-mails are not protected
against
access by third persons and, therefore, their confidentiality and/or integrity
may
not be assured. Moreover, despite our use of anti-virus software, a virus may
enter
your systems in connection with the sending of e-mails. Thus, we are not liable
for
any damages resulting out of these circumstances.
|