Bill--Tell Rosey that her pins should be placed at eight and two
o"clock, when viewed from the back, looking toward the engine. These two
holes should be barely large enough to accept the 3/8" dowels. You may
have to clean them out.
Dick
From: anabil007@comcast.net(Bill & Skip Pugh)
Hi Folks,
I need to know the
correct placement of the engine rear plate to transmission dowel pin(s)
placement. They are missing in Rosey (TR6) and I would like to
replace them correctly. From the transmission holes, one appears to be
around 10 o'clock, but if there is a more exact placement I would
appreciate it.
Thanks for your help
--
Bill Pugh
1957 TR3 TS16765L
aka
Casper
1970 TR6 CC59179L
aka
Rosey
Wallace, CA
|