Everything is out of the car. The dash is refinished, and the new wiring
harness is going in. Might as well replace the steering column bushings.
Any tricks for removing the ignition switch mechanism that is mounted on the
column so I can pull it out through the dash? Any info would be greatly
appreciated.
Thank you,
John Zimmerman
Mfg. Planning / Traffic
Demag Plastics Group
11792 Alameda Drive
Strongsville, Ohio 44149-3011
Phone: (440).876.6251
Fax: (440) 876.8977
email: john.zimmerman@dpg.com
DISCLAIMER:
The information transmitted is intended only for the person or entity to which
it is addressed and may contain confidential and/or legally privileged
material.
If you received this in error, please contact the sender and delete the
material
from any computer. Any review, retransmission, dissemination or other use of,
or
taking of any action in reliance upon, this information by persons or entities
other than the intended recipient is prohibited.
You have asked us to correspond with you via the Internet per e-mail. However,
the written version of our document signed by us is the only authoritative
version.
Please note that e-mail correspondence can be lost or falsified, with or
without
any interference by third persons. Conventional e-mails are not protected
against
access by third persons and, therefore, their confidentiality and/or integrity
may
not be assured. Moreover, despite our use of anti-virus software, a virus may
enter
your systems in connection with the sending of e-mails. Thus, we are not liable
for
any damages resulting out of these circumstances.
|