Todd:
Pins 11 and 12, White/Orange and White/Red wires.
No need to jumper them though. Just disconnect the seatbelt
switches, and the neutral switch on the tranny. The neutral switch wire
comes into the passenger compartment in the passenger footwell, and is
Green/Light Green. It goes to pin 7 on the seatbelt module.
Vance
-----Original Message-----
From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net] On
Behalf Of Todd Bermudez
Sent: August 26, 2005 10:05 AM
To: Hone Richard A NPRI; 6pack@autox.team.net
Subject: Re: Seat belt module
Richard,
There are these lovely little metal "wafers" located
under each of the seats. You had to sit in the car &
have the belts done. They're plugged into the
Seatbelts...then of course it works it's way throught
transmission(switches on top of the gearbox) & then to
that lovely little buzzer next to the heater box on
the inside of the car...it would be on the passenger
side. Some PO took pulled the white connector out of
the buzzer & jumpered 2 wires (next to each other) &
the car starts without the buzzer or without the seat
belt modules being sat on.
One of these days I'm gonna remember which 2 wires
they are?? Perhaps when I go out to the car today.
Todd Bermudez
CD198L
CF25768UO
|