On Sun, 14 Aug 2005, Shannon Muncy wrote:
> Hello everyone,
>
> As in a post I started a few days ago, I decided to get a Mallory
> Unilite distributor and convert my tach to electronic using the
> expertise of APT Instruments (www.gaugeguys.com).
>
> My distributor is in, and I'm reading the instructions about
> installing my drive dog on the new Mallory and I get confused. The
> instructions mention nothing about the orientation of the drive dog in
> relation to the rotor.
>
> My question: Is the orientation from the drive dog to the rotor
> important? It seems to me that where ever the new drive dog is
> installed, I can always compensate by moving the plug wires on the cap
> and/or turning the dizzy. Does this seem right?
You are much better off aligning the drive dog with the rotor as exactly
as possible. Doing so makes any "gross adjustments" a heck of a lot
easier... for example installing the distributor.
> Thanks for any advice,
> Shannon
>
> 72 TR6
regards,
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-linux-help |
Voice:617-253-7438 FAX: 617-258-9535 | Cell: xxx-xxx-xxxx
------------------------------------------------------------------------------
|