>===== Original Message From "Navarrette, Vance" <vance.navarrette@intel.com>
=====
> Folks:
>
> I need some advice... I have put new brake lines in my car,
>using the automec kit sold by moss. My old brake lines were extremely
>rusty, so I tossed em. The automec kit comes with the lines precut and
>all the fittings installed. As you recall, there are two lines going
>from the Master Cylinder (MC) to the PDWA assembly on the fender well.
> Here is my question: Are those 2 lines routed front MC to back PDWA
>and back MC to front PDWA, or are they routed front MC to front PDWA and
>rear MC to rear PDWA?
>
My brakelines cross between MC and PDWA, the back side of the MC (closest to
the servo) is the half that provides fluid to the front brakes (the resevoir
division will give you a hint). It does seem confusing though.
Shawn J. Loseke
Fort Collins, CO
http://www.triumphowners.com/79
|