Re: Brake Servo

[TRsick@aol.com]

Jerry:
    Most powders cure in the oven from 350F - 400F. I  believe there is a 
rubber bladder in the servo, so the heat would run it. To do  it right, you 
would 
have to powder coat & cure the servo case before final  assemble.
    Good Luck
    Bob
_www.capecodpowdewrcoating.com_ (http://www.capecodpowdewrcoating.com) 
 
From: "Jerry C Shaw" <slowtoaccept@yahoo.com>
Subject: Re: Brake  Servo

Just wondering how hot the powder coating oven gets, and whether  this does 
damage to the internals of the brake  servo?