On Thu, 14 Apr 2005, Scott Tilton wrote:
> Hi!
Hi Scott.
> Was wondering if anyone out there had any information they'd be
> willing to share about adapting a modern (ATI possibly) harmonic
> dampener to a Triumph 6 cylinder enigne?
It is possible. Big $$$. Figure about $400 to get one on there.
They need the actual dimension of your crank snout to the .0001" (that's 1
10,000th of an inch).
FWIW, the snount dimension is very similar to a Ford V6 (not sure _which_
Ford V6, but my machinist told me this a couple of years ago.)
But if you go with ATI, forget about the notion of an off-the-shelf part.
This will be a custom order.
> Thanks in adavnace.
>
> Scott Tilton
regards,
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-linux-help |
Voice:617-253-7438 FAX: 617-258-9535 | Cell: xxx-xxx-xxxx
------------------------------------------------------------------------------
|