I would be interested in the replies to this question. Could you copy me
or post them to the list?
Thanks,
Don Malling
STEVE STERN wrote:
> I purchased my 1976 TR6 only a few months ago. It had undergone a frame off
> resto a couple/few years earlier but was limited to the frame, body and
> interior. No mechanicals. Because of 5/16-3/8" wide upper door gaps I laid
> under the car for most of an hour checking frame details and it looked great.
> The po had jobbed this work out. Because of a number of uneven gaps I
> concluded that they were just sloppy on a lot off finish details. I have since
> realigned most. So far in my short ownership the door gaps don't seem to have
> changed. I want to tighten them up a bit but after looking thru the many books
> and catalogs I have it's not real clear to me where all the rear mount point
> are that I must loosen and shim. I know that I read this can be done but can't
> remember where. Can anybody out there who has done this enlighten me?
> Thanks, Steve
|