Joe Davis wrote:
I've found a 3/4" rear roll bar locally (I think as supplied by Moss?). It
is NOT adjustable. I understand that most good matched front and rear bars
are equal diameter, but the rear is adjustable. I believe the stock front
bar is 7/8"?
Joe,
The stock front bar on a TR6 is much smaller than 7/8". I believe that the
stocker was 9/16" in diameter. If you are going to use a 3/4" bar in the
rear, then the smallest front bar you should consider is a 3/4" - I think
that Addco matches their 3/4" rear with a 7/8" front.
Hugh Barber
Hollister, CA
'73 TR6
|