Bill,
It looks like a trip to the hardware store is in order. When you have an
opportunity, could you give me the specs on the bolts?
Thanks.
Mike
>>> Bill Moine <bmoine@yahoo.com> 01/03/04 12:00PM >>>
My parrish hardtop is connected to the windshield with 2 bolts,washers and
wingnuts along with the 2 turn buckles in the rear.
My top is atleast 20 years old and I was please to find out you can also get
any seals etc from www.smoothline.com just specify you have a parrish top.
They now sell the top with stainless steel hardware.
>Date: Fri, 02 Jan 2004 21:03:48 -0800
>From: "Michael Corbitt" <Michael_Corbitt@ous.edu>
>Subject: Hardtop Hardware
>
>The TR6 I purchased last summer came with a Parrish style hardtop. The
>only mounting hardware it came with are two turnbuckles for cinching
>down the rear sides. There was no hardware for mounting the front edge
>to the windshield, but it has holes where I would expect pins to be
>located. Are these holes supposed to be threaded to accept a bolt up
>through the underside of the windshield? It just doesn't seem like the two
>turnbuckles are sufficient, plus I doubt there's a decent seal for the
>front edge of the top when it's wet out. And here in Oregon it's known
>to rain once in awhile.
>
>Any information on how this is supposed to tie down would be
>appreciated.
>
>Mike
|