Prothane makes a full line of their red poly bushings for the Triumph, most of
which, I believe, are sold by TRF. The Prothane website
(http://www.prothane.com) has some pictures but no direct application data,
unless you buy their catalog. I've installed pretty much all Prothane throughout
(except the die mounts) and had no problem installing them.
Dave Friedlander
CF25194UO
Hugh Barber wrote:
> >Additionally, I purchased new poly bushes from BP Northwest for the
> trailing
> arm mounts. I thought I read somewhere that the bushes where split down the
> middle for easier installation but these are a solid piece?? Any
> thoughts?.....
>
> When I purchased poly trailing arm bushings from BPNW, they were split (ie:
> two halves for each bushing). Perhaps they have changed their design. I
> was less than satisfied with the BPNW bushings I used, since after about
> 4,000 miles I experienced "cold flow" in the bushings. I currently use Good
> Parts bushings (I think they're either delrin or nylatron) and am very
> satisfied with those.
>
> Hugh Barber
> Hollister, CA
> '73 TR6
|