Good afternoon,
I'm in the process of installing a new harness from TRF and refinishing my
dash. When I pulled the old harness out, some of the brown wires were
burned. It looks like it went back to the light switch. I seem too remember
an issue on the list a few years ago about there being two different switches
available and that one was better than the other. Can someone out there
refresh my memory? I really don't want to go through this again any time in
the near future.
The other question concerns mounting the switch into the dash. Is there
supposed to be some kind of clip or ears on the switch to hold it in place?
The switch I have kept popping out of the dash.
Any information would be greatly appreciated.
Thanks in advance,
John Z
DISCLAIMER:
The information transmitted is intended only for the person or entity to which
it is addressed and may contain confidential and/or legally privileged
material.
If you received this in error, please contact the sender and delete the
material
from any computer. Any review, retransmission, dissemination or other use of,
or
taking of any action in reliance upon, this information by persons or entities
other than the intended recipient is prohibited.
You have asked us to correspond with you via the Internet per e-mail. However,
the written version of our document signed by us is the only authoritative
version.
Please note that e-mail correspondence can be lost or falsified, with or
without
any interference by third persons. Conventional e-mails are not protected
against
access by third persons and, therefore, their confidentiality and/or integrity
may
not be assured. Moreover, despite our use of anti-virus software, a virus may
enter
your systems in connection with the sending of e-mails. Thus, we are not liable
for
any damages resulting out of these circumstances.
|