Hi,
I'm putting together another motor and I'm using a late TR6 block (with
the recesses for the fire-rings in the head gasket). I want to use a
copper head gasket and steel o-rings to get a good seal. The intended
final compression on the motor will be about 12.3:1.
If you have a TR6 and are considering this sort of option, please contact
me off line. I'm going to have Mordy Dunst (www.headgasket.com) make up
some steel rings, but I want to get a couple of other folks to provide
some dimensions on how deep the recesses are in the block. I only have two
'72 blocks to measure, so having a few more sample dimensions would be a
good thing - and Mordy can keep the pattern around in case anyone else
wants to do this.
If you've already figured this out - I'd like to hear those experiences
also.
regards,
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-vms-help |
Voice:617-253-7438 FAX: 617-258-9535 |
------------------------------------------------------------------------------
/// 6pack@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|