Alan,
I know they are supposed to be there, but they are a real pain in the ....
to put in. If no one has them you can probably make them by bending some
thin steel about 1 inch wide and 1.75 inches long. Put a "S" curve
across the 1 inch dimension about 1/2 inch from one of the ends on the
1.75 inch dimension. You'll probably have to trim to fit but basically
all this is a clip to hold a cover over the folding mech on the seat.
Mine also had small fiberboard spacers that mounted between the clip you
just made and the fiberboard insert.
I had seat covers from Vicki Brit, They did not fit real well and to make
them fit I left my inserts out. The seats seem to work OK without them.
Regards,
Steve
Tr6@kc4sw.com
-----Original Message-----
From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net]On
Behalf Of Alan
Sent: Thursday, May 01, 2003 9:19 PM
To: triumphs@autox.team.net
Cc: 6pack
Subject: seat parts
My new seats came with the fiber board inserts that go into the side of
the
seats. Who ever redid the seats that were in the car when I got it (DPO,
maybe), didn't re-install them.
Problem being, is that there was a metal mounting bracket that is supposed
to
be reused on the new inserts. which I don't have now.
Would anyone have any of these trinkets (should be 4 of them) they would
be
willing to sell me.
Thanks
Al Salvatore
76tr6
[demime 0.99d.1 removed an attachment of type application/x-pkcs7-signature
which had a name of smime.p7s]
|