Looking for the List's opinion (again) for a tool recommendation: Blast
Cabinet.
I recently purchased a 1971 Triumph Stag, and dismantling it for a ground
up restoration. The car has been sitting for over 15 years, and many of
the parts need work (i.e., part washer bath, re-plating, or re-finishing).
I figured a "Blast cabinet" would be a good investment, given the shear
number of part requiring attention.
I own a Porter Cable compressor (2 HP, 4 Gal. Model #CF2400, 8.3 SCFM @
40psi ; 6.1 SCFM @ 90psi).
I searched Harbor Freight
(http://www.harborfreight.com/cpi/ctaf/Category.taf?CategoryID=505&pricetype=)
for ideas... and found a couple there, but not sure what will work best
with my compressor and needs.
Models vary widely on features, size and compressor requirements (top
versus side openings; air flow versus working pressure; canister dust
collector versus hopper) - and I'm confused.
Your assistance please.
Thanks everyone.
samples:
Central Pneumatic
ITEM 1672-6VGA $79.99
Required air pressure: 100 PSI
Required air flow: 5 CFM
ITEM 45411-1VGA $89.99
Working pressure: 80-120 PSI
Corey Sherman
cm.sherman@verizon.net
|