The hoses I got were for the PI version (it was a complete set) they did not
have the carb heater pieces but the top hose was one piece without the
emissions fittinr.
On the other hand I've found mine runs better, especially cold, with the
emissions stuff in
Steve
tr6@kc4sw.com
-----Original Message-----
From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net]On
Behalf Of Gary Radocchio
Sent: Wednesday, October 23, 2002 10:25 AM
To: 6pack@autox.team.net
Subject: Water Hoses
Does anyone sell replacement hoses specifically made for the TR6 that
are one piece (not containing all the emission fittings)?
Thanks
Gary R
74 TR6 CT
-----Original Message-----
From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net] On
Behalf Of Vink, Graham
Sent: Wednesday, October 23, 2002 9:33 AM
To: 6pack@autox.team.net
Subject: RE: oil guage-to-pipe leather seal, dash bulb question
I got an oil seal from Moss recently; about 50 cents.
would love to know if you can use the higher wattage bulbs. the concept
of
being able to SEE gauges at night is an exciting one!
Graham
-----Original Message-----
From: RPVanLuchene@lbl.gov [mailto:RPVanLuchene@lbl.gov]
Sent: Tuesday, October 22, 2002 8:35 PM
To: 6pack@autox.team.net; triumphs@autox.team.net
Subject: oil guage-to-pipe leather seal, dash bulb question
This seal on my oil guage is shot (black-rimmed gauges). I see it is
not avail at TRF, part #54902. Anyone know of a good substitute, or of
a vendor that may carry this part?
I got a couple 24V 3.3W bulbs with my dash light bulb kit from LBCarCo
along with the mostly 12V 2.2W ones that the Bentley calls for. Is it
OK to use these 3W bulbs or will it screw up the electric system.
Thanks,
Ryan
71 TR6
|