Pushrods with milled head

["Matt M." <afterburn27@yahoo.com>]

I recently built the engine in my TR6, and I ran
across this same problem. I assumed the old pushrods
would work because I wasn't milling too much off the
head, but I was wrong. I ended up purchasing tubular
pushrods and cutting them down to size. The ends of
the tubular pushrods will just snap on and off and it
is a simple job for a machine shop to cut them to any
size you want. Hope this helps...

                                -Matt, '74 TR6
Yahoo! News - Today's headlines
http://news.yahoo.com