Charlie:
If your car is an early model ('69-72) you should be able to remove the
propshaft without removing the exhaust. Loosening the exhaust should allow
you enough clearance to remove the shaft by pulling it forward from
underneath the car. This was my experience with my '69 TR6.
Good luck!
Walt Fogle
Woodinville, WA
>
>Am replacing the six u-joints on the TR and see that the exhaust system
>runs
>directly in the path of the drive shaft. Is there a way to get the drive
>shaft out though the
>top (by removing the seats and carpeting)? My exhaust system is welded so
>I'd either have to cut the pipes or if I unbolt the back will the system
>hang low enough for me to get to the bolts?
>
>Thanks for any suggestions.
>Charlie
_________________________________________________________________
|