When I did the springs I had an unusual situation. I was working on the car
in the back of a friend's factory. He had a huge great monstrous hydraulic
press and a metal strapping machine for crates. You can see where this is
going can't you? I put each spring in the press squished it down good and
then used a thin metal strap to tie them down. Then I just dropped them in
place and cut the strap with a tin snip with long handles. The spring
thunked into place and I pulled out the strap with some vicegrips. Worked
great the first time. The next time I tried that trick, I left the
compressed springs standing on the ground for a moment while I prepared. I
guess the straps were a bit marginal. I was under the car and heard a great
BOOOING!!!, followed by a crash as one of the springs shot through the air
and landed in the parts depot a hundred feet away. Just imagining what would
have happened if I had been holding the spring when it let go made me feel
queer all over. Last time I tried that trick I can tell you.
Mark Hooper
-----Original Message-----
From: Darrell Walker [mailto:darrellw@inetarena.com]
Sent: Friday, April 12, 2002 10:11 AM
To: Walt Philipson; 'R. Ashford Little II'
Cc: '6-Pack'; tr list list
Subject: Re: Front spring trouble
As someone who's BTDT a few more times than I would have liked:
-The spring compressors from Moss and/or TRF are nice, but nothing you can't
fabricate on your own.
-Use a little lubricant on the treads of the compressor, makes things a bit
easier.
-Use a jam nut on the end of the rod you don't want moving on the threads.
Usually this is the top, but once, when installing the springs on a bare
frame, I locked the bottom. Much easier to turn, but not the normal case.
-Use two long bolts as guides when reinstalling. Use them in the center
holes.
--
Darrell Walker
66 TR4A IRS
|