Hi Brad,
I understand that attempting to remove the flange without using a proper
tool that pulls evenly on the studs usually destroys the flange. This
reduces the $150 core credit to $0. I run my axels until the bearings
get pretty loose and then go for a rebuilt unit.
Nelson Riedel
Granville Ohio
'68TR250, '70TR6, '76TR6
Subject: Rear Hubs
| Hi
| I am working on cleaning up my rear hubs and putting new bearings in. In
the
| TR6 bently manual it says to use a tool to remove the flange so you can
take
| the bearings out.....is it a "must" to use this tool or can something else
| be used? Thanx
| Brad
| 71 TR6
|