No, but the overall dimensions are as follows:
Width/beam: 4'10" (58")
Length: 12'11" (155")
Wheelbase 7' 4" (88")
According to an original 1974 TR6 British Leyland brochure, these
measurements are published as follows:
A] Rear Deck shelf depth 17" (seat fully slid forward)
B] Rear Deck sill height 9"
C] Pedal to seat back 36" (seat fully slid forward)
D] Floor pan to seat sill 7" (front of seat cushion)
fig. 1 TR6 cross view
front rear
| ______
| D |
\ | A
\ |
\______________________| B
C
I figure approximately 5'8" (69") + 20% for good measure.
The beam is probably less than 4' taking in account the door sills and
transmission tunnel.
So, their standard 5' x 8' should be more than enough to cover the
interior floor pan, foot well, and rear wall & sill. This is of course an
educated guess. I haven't really measured the car yet and that would be
the most accurate.
__________________
Corey Sherman
corey.sherman@rcn.com
"Creamer, Mark" <CreamerM@cintas.com>
Sent by: owner-6pack@autox.team.net
08/20/01 03:57 PM
Please respond to "Creamer, Mark"
To: triumphs@autox.team.net, 6Pack@autox.team.net
cc:
Subject: RE: foil insulation
Corey, how many sq feet are necessary, do you know yet?
-----Original Message-----
From: corey.sherman@rcn.com [mailto:corey.sherman@rcn.com]
Sent: Monday, August 20, 2001 3:45 PM
To: triumphs@autox.team.net; 6Pack@autox.team.net
Subject: foil insulation
Has anybody ever used "Insul-Tek" foil insulation... I was thinking of
installing it over my floor pans under the carpeting. Any
thoughts/suggestions. This is a little pricey. 40 Square Feet Julianos
Insul-Tek $45.00
NFI
http://www.julianos.com/insultek.html
________________________
Corey Sherman
corey.sherman@rcn.com
|