Hi Brad:
Though it's a tight fit you won't damage the seal when you install it over
the plunger. Try immersing the seal in some hot water for a few minutes to
soften and expand it a bit. Wiggle and squeeze it until it slips over the
plunger. Good luck!
Walt Fogle
'69 TR6, CC30689L
Woodinville, WA
>
>HI i just bought a kit for the brake master cylinder with new seals and
>all. I'm not sure how to get the seal over the plunger....i got the old one
>off just by prying with a screwdriver....but i am afraid that this would
>ruin the new seal....anyone done this before I could really use some help.
>thanx Brad
>_________________________________________________________________________
_________________________________________________________________
|