Date: Tue, 8 Aug 2000 21:25:23 EDT
From: Trsx69@aol.com
Subject: Re: Pozidrive screwdrivers
In a message dated 8/8/00 6:48:12 PM, pmachold@pluto.njcc.com writes:
<< This is a follow-up to an email about the Pozidrive screws on our carbs.
After the posting, I got to thinking that I should buy a PZ2 screwdriver
instead of using the Phillips head that I usually use to remove the carb
dashpot. The Phillips screwdriver has begun to strip the heads and made
the screws look a bit messy.
I checked a few hardware and auto supply shops but couldn't find any
Pozidrive drivers. Finally, I looked at Sears Craftsman tools. They do
not make one piece Pozidrive screwdrivers but they do have Pozidrive
bits. These bits fit into a magnetic handle, also sold by Sears. The
part number for the package of bits (containing the sizes PZ1, PZ2 & PZ3)
is 925644 and they cost $4.99.
Peter Macholdt
TR250
Peter Macholdt
609-466-2127 Phone
603-925-3050 FAX
Hi Pete,
I got a set of three sizes from our MAC tool guy, I think itt cost me 40
bucks.
regards
Jim Holewka
New screws are pretty cheap. I replaced mine with standard phillips-head
stainless steel.
Regards/John Truttman/TR6/Santa Cruz
|