RE: accelerator pedal bushing

[Cliff Davies <cdavies@holzher.com>]

John,
I can't imagine getting those bushes in from the interior.
Here is what worked for me, heat the bushes in a dish of water 
in the microwave a couple of minutes each. I put some grease 
in the hole and then using needle nose pliers placed the bottom 
of the bush in the hole, holding the top part of the bush with the 
pliers forced until it sat nicely in the hole, the second one goes 
allot easier, did I mention I did this from the engine side.
Good Luck,
Cliff
73 TR6