----- Original Message -----
From: "Valerie Stabenow" <hlub34a@aeroinc.net>
To: "Sally or Dick Taylor" <tr6taylor@webtv.net>
Sent: Tuesday, June 13, 2000 7:02 AM
Subject: Re: Float height
> DICK!!
>
> far be it from me to have the ability to supercede your
knowledge!!!!!!!!!!!
> You probably have forgotten more about bc's than I'll EVER know....
>
> I was curious about the grose jets, because I installed them on several
> cars...I didn't use anything "scientific" to set the height.....a Sears
> Craftsman ratchet extenstion is 17 mm and it seemed to work. This last
time
> I put GJs in the 4a carbs and I didn't change any float height and the
> bugger seems to run just fine. I was asking about where to measure the
float
> height from (hold carb lid upside down and check from the rim edge
???????)
> The shop manual has a nice drawing that illustrates it. Since I didn't
mess
> with the float height, this particular thread got me thinking that maybe I
> should have....
>
>
> Valerie
>
|